14
connect the other end to the cable connector provided by your ISP.
3. Connect one end of the power adapter supplied with the OG3000 to the OG3000's power port and the other
end to a household power outlet.
4. Wait for OG3000 to connect normally. This process can take 3 to 5 minutes. When all the Itemss on the
front panel of the OG3000 (POWER, DS, US, 2.4G, 5G, ONLINE, TEL1, TEL2) are on. The device is online.
5. Connect one end of the coaxial cable (RJ-45) to the corresponding cable connector on the back of the
OG3000 and connect the other end to the personal computer. Verify that you have Internet access on your
personal computer.
6. In accordance with the wireless access point and password configured on the label on the bottom of the
OG3000, use a wireless device to connect to the OG3000 and verify that the wireless can access the Internet.
7. If telephone service is activated, connect one end of the telephone cable (RJ-11) to the corresponding
connector on the back of the OG3000 and the other end to a telephone or fax. Then use the telephone
number assigned by your ISP and try dialing another telephone to verify that the telephone service is
normal.
Cautions:
To connect more Ethernet devices (such as multiple computers) at the same time, use
a multiport Ethernet switch.
The cable's signal distributor must be installed to connect it to a television, set-top box or video player
at the same time.
3.2 Network Status
The installer can use the computer to access the device management IP address 192.168.0.1, open the WEB
GUI and can see the current network status of the device without entering a password. Check if the device
has opened the correct service.
On the page, you can view the wireless access point information, the LAN information, and whether the WAN
port has obtained the IP assigned by the ISP to access the Internet.
Summary of Contents for OG3000
Page 1: ...Model No OG3000 Embedded Multimedia Terminal Adapter User Manual...
Page 2: ...2...
Page 16: ...16...
Page 30: ...30...
