T H E C O N T I N U O U S P O W E R C O M P A N Y
Page 12
INVERTER - This indicator identifies the status of the regenerated, conditioned protected
output power. This indicator will stay ON as long as protected power is available from the
power inverter generator.
AC IN - The utility input indicator that identifies status of the line voltage. If the line voltage
is within the specified range, it will remain lit. If the AC input is out of range, but present,
the indicator will slowly blink.
LOAD LEVEL - This is the system output capacity status bar. The number of LEDS
illuminated indicates an approximate percentage of system load. All green LEDS
illuminated would indicate full load. The top red LED illuminates on over-loads.
BATTERY LEVEL - This is the battery status bar graph. During normal operation, this bar
graph will show the charging of the battery; all indicators lit will represent a fully charged
battery. During battery operation, this bar graph represents a discharge meter indicating
less battery time available as each light goes OFF.
COLD START - A momentary push-button switch to activate the system in the event no
utility power is available. The system will be allowed to start up by using power from the
battery. Depress this switch, the indicator above it will light, and hold it in until the audible
alarm beeps once. The system will maintain a load for a period of time depending upon the
condition of the battery. DC INPUT breaker must be ON.
ALARM - This is a fault indicator that will light in the event that the inverter generator is non-
operable. This could be due to an over-temperature situation or an inverter malfunction.
ALARM SILENT / TEST - A momentary push-button switch that controls two different
functions depending on the mode of operation. In the normal mode of operation, if this
switch is depressed and held in, the above indicator will blink. Once it stops blinking, the
unit will perform an internal 1 to 2 minute battery check. Once the test is completed, if the
battery is below standards, the system will indicate that the battery needs replacing. The
system will not run this battery test unless the battery is detected as fully charged. The
audible alarm on the unit will be disabled. This is set at the factory.
NOTE - Cold Start and Alarm Silent switches must be held in for at least two
seconds to engage their function. This is to prevent any inadvertent switch
operation.
!