6. Take out the coach bolts, washers and nuts for attaching the saw.
Read the instruction manual which comes with the saw.
7. Insert two of the coach bolts through the slots in one of the mounting brackets and through
the mounting holes in the saw from underneath.
8. Pass the washer over the bolt from the upper side of the saw and screw on the nut.
Tighten the nuts, do the same with the other mounting bracket.
9. Make sure that the saw is securely mounted on the mounting brackets.
Insert the coach bolts up through the slots
in the mounting brackets from underneath,
pass a washer over the end of each bolt
and then fasten each bolt with a nut.
On some saws, there can be limited space
for the front coach bolts when the saw is
turned, in this case the bolts should be
inserted through the slots from above and
the washers and nuts fastened underneath.
5
English
