8
English
Operation
1. Switch on the helicopter, the blue light will come on.
2. If there is not enough vacant memory on the SD card, the camera indicator light
will flash red. If this happens, you will not be able to take photos or video until
the SD card has been emptied or changed.
3. Press [ Photo ] on the controller to take a picture. The camera indicator light will
flash red once.
4. Press [ Video ] on the controller to record video, the camera indicator light shines
green. Push it again to stop recording.
5. If the memory runs out during use, the red camera indicator light will start to flash.
Transferring stored data
Troubleshooting guide
Problem
Reason
Solution
The rotor doesn’t spin.
1. The switch is in
the
OFF
position.
2. Low battery.
1. Set the power switch
to
ON
.
2. Recharge the battery.
The helicopter stops
suddenly and plummets
to the ground.
Low battery.
Recharge the battery.
The helicopter does not
respond to the controls.
Wrong frequency.
Change the frequency
setting.
The helicopter responds
incorrectly to the controls.
•
Another unit is using
the same frequency.
•
Strong sunlight is interfe-
ring with the IR signal.
Change to another room.
Specifications
Operating time
Approximately 5–8 minutes
Charging time
Approx. 40–50 mins
Battery
Controller: 6 × AA/LR6
Helicopter: 1 × 3.7 V lithium polymer (rechargeable)
Memory card
1 GB MicroSD (included)
Length
28 cm
Connect one end of the USB cable to
the helicopter and the other end to
your computer.
