Clas Ohlson 36-8120, Manual

5

English

On/off

1.  Turn on the fan using the power switch (10). The fan is now in standby mode.
2.  Start the fan by pressing [ (((infoga på/av symbol))) ] on the remote control or the control panel on 

the fan.

3.  Turn off the fan by pressing [ (((infoga på/av symbol))) ] on the remote control or the control panel on 

the fan.

4.  If you do not want the fan to be in standby mode you can turn this off using the power switch (10) on 

the back of the fan.

When switched on for the first time, the fan will start with the following factory settings:

- - Heat setting: LOW, the corresponding icon is shown on the display.

- - Oscillating function: off, the icon will not appear on the display

- - Timer: 0, the icon will not appear on the display

- - Fan: On

- - Temperature: 25 °C

- - Decorative flame effect: On

- - ECO function: off, the icon will not appear on the display

The ECO function: 

The default factory setting for the temperature is 22 °C (you may set another temperature if you want). 
If the ambient temperature is lower than 18 °C the fan will run at high power. If the temperature is 18–22 
°C the fan will run at low power. If the temperature is higher than 22 °C the heating element will turn off.

Heating a room to the preferred temperature

Note:

 Bear in mind that factors such as the size of the room, the outside temperature and how well 

the building is insulated, all affect the ability of the heater to warm the room up. If the room is too large 
the ability of the heater to warm it up to the desired temperature may be insufficient. The temperature 
range of the thermostat is approx. 5–35 °C.
•  The fan heater will heat the room until the set temperature is reached. Once the temperature falls, 

the fan heater starts up and heats the room until the set temperature has been reached.

Timer

•  Set the time for how long the fan is to run before it automatically shuts off. 
•  Each button-press changes the time by 1 hour.
•  You can reset the time at any time. Wait for 5 seconds after you have adjusted the setting and the new 

time will be saved automatically.

•  If the timer is set to “0” then it is not activated.

Setting the desired temperature

•  Set the desired room temperature (15–35 °C).
•  Every button press changes the temperature by 1°.
•  You can reset the temperature at any time. Wait for 5 seconds after you have adjusted the setting and 

the new time will be saved automatically.