Clas Ohlson A5960, User Manual

4

EN

G

LI

SH

Wall installation indoor/outdoor

For installation on wood

Step 1  Mark with a pen where the antenna should be placed: (Use the multi attachment as template for 

the marking)

Attach the multi attachment with the included screws. Use a screwdriver.

Installation on concrete or cement.

Step 1  Mark with help of the multi attachment where to drill the hole. Put e.g.  (if the wall is shiny) a piece 

of tape on before marking. To make sure that the drill does not slide during drilling. Use a concrete 
drill size 5.8 mm and drill a 35 mm deep hole.

Mount expander plugs in the drilled hole. 

Attach the multi attachment with the included screws. 

Step   Mount the antenna on the multi attachment.

Step 3  The antenna cable connects to the antenna’s F-plug and the plug in the other end connects to the 

TV or the Digital TV receiver. The F-plug should be screwed on to the antenna and then covered 
by the moisture protection. 

Remember to make a drip loop so that water can not come in through the cable.

Step 4  Adjust the direction of the antenna for best reception.

Mounting on a mast

Step 1  Mount the  U-bolts onto the multi attachment and screw on the wing nuts a little.

Step   Lower the multi attachment with the U-bolts over the mast to the point where the antenna is to be 

mounted. If the multi attachment can not  be lowered over the mast due to it being too high, you 
can mount the U-bolts while the multi attachment is placed on the mast. The wing nuts can then be 
mounted.

Step 3  Tighten the wing nuts – however not too much so the antenna will not turn.

Step 4  The long antenna cable connects to the antenna’s F-plug and the plug in the other end connects 

to the TV or the Digital TV receiver. The F-plug should be screwed on to the antenna and then 
covered by the moisture protection. 

Remember to make a drip loop so that water can not come in through the cable.

Step 5  Adjust the direction of the antenna for best reception.

Step 6  Now tighten the wing nuts so much that the antenna will not move or turn.

Technical specifications:

Frequency range: 

VHF 47 – 30 MHz

UHF 470 – 890 MHz

Amplification 

0 dB ±3 dB

Power consumption 

5 V/40 mA

With reservation of changes and specifications.