5
E
N
G
LI
S
H
Programming the remote control
1. Entering device code
enter the code in the following manner:
1. Open the included code list and look under the headline for
the type of device that corresponds to your equipment.
TV Brands
Codes for TVs.
VCR Brands
Codes for VCRs.
SAT Brands
Codes for satellite receivers as well as codes
for digital receivers for cable TV and terrestrial
television broadcasting network.
CTV Brands
Codes for analogue cable TV receivers.
DVD Brands
Codes for dVd players.
Under this headline you then look for the code
that corresponds to the brand of your device,
for example Philips. every code contains 4
digits. If there is more than one device code for
your brand, you begin with the first one.
. Turn on, for example, the TV manually or with the original
remote control. Choose channel 1.
. Press the button for desired device, for example
[ TV ]
By first pressing the
[ SHIFT ]
button and then button
for desired device access is granted for controlling and
additional 4x of devices.
4. Press the buttons
[ CH + ]
and
[ VOL- ]
simultaneously for
seconds until the led light is lit.
5. enter your four digit device code with the buttons
[ 0 ]
–
[ 9 ]
.
The led light is directly turned off.
Test the function of the remote control with the device that you
have just programmed. If the device responds correctly to the
buttons you press, you have entered the right device code.
Otherwise, you will have to repeat the procedure above with the
other device codes available for your brand until your device
reacts in the right way when you press the buttons and until
most buttons work correctly.
In the same manner, you set the device codes for other devices
as well. Just remember to press the button for device type in
step above.
Summary of Contents for BW6390
Page 2: ... ...
Page 43: ...4343 ...
