1
EN
G
LIS
H
6. Starting to Exercise
6.1 Basic use
Activating the display
Push one of the buttons or start pedalling to activate the display. If the display does not work, make sure that
the AC/DC adaptor is correctly connected.
Tension
The tension is represented by bars on the display, a high bar represents a high tension and a low bar repre-
sents a lower tension. The tension can be altered whilst you are exercising using [UP] and [DOWN].
Targets
Every exercise program has various targets which you can set, such as the workout time, distance travelled,
or number of calories burned.
To Pause
Push the [ST/SP] button whenever you would like to pause the training programme. The measurement will
pause and the display will show the current values. Push [ST/SP] again to resume the programme.
To change the function whilst training
Push [ST/SP] to stop the current programme. Push [UP] or [DOWN] to select another programme, confirm by
pushing [ENTER].
Resetting
To reset set programmes, push [ST/SP] and hold it in for seconds. The computer will beep and the display
will briefly show every sequence of the programme.
6.2 Selecting an Exercise Programme
Explanation of the menus/programmes
No.
Programmes
Explanation
Targets/Settings
1
Manual
Exercise programme with or without set
targets. The tension can be manually
adjusted whilst exercising.
- TIME
- DISTANCE
- CALORIES
2
Rolling
Preset programme with varied tension
throughout the workout.
- TIME
- DISTANCE
- CALORIES
Valley
Preset programme representing the ups
and downs of a valley.
- TIME
- DISTANCE
- CALORIES
4
Fat Burn
Preset programme representing an
upward slope and a downward slope.
- TIME
- DISTANCE
- CALORIES
5
Ramp
Preset programme with gradually
increasing tension.
- TIME
- DISTANCE
- CALORIES
Summary of Contents for ER-6472C
Page 2: ......