7
E
N
G
LI
S
H
5. Insert a negative or slide into a holder and close it. Setup:
Pull up the tab with the white arrow on the side of the film holder. Open the film
holder and insert the film so that the perforations fit onto the fasteners in the
film holder. Close the film holder securely over the film. Make sure to mount
the film right side up. You can rotate the picture with the software but you can-
not create a mirror image.
6. Insert the holder into the scanner from the right. The side of the holder to be
inserted has a directional arrow on it and also has a corner missing.
7. Click on
Acquire.
8. A preview image will then be displayed. Click on
Snap Shot
or press the
scanner’s [COPY] button (The COPY button only works when the image is
shown in this mode).
9. Click on
Transfer
to save the picture. Saved images are displayed on the film
strip at the top of the screen.
• In order to achieve the best possible picture quality wait 5 seconds after pres-
sing
Snapshot
or
Transfer
so that the scanner has a chance to calibrate in the
white balance.
• The ”Exposure compensation” feature allows for manual exposure adjustment
which allows you to lighten or darken the picture for the best possible results
for the scanned picture. Click
●
or
☼
to adjust the exposure which allows you
to see the results directly.
• Processing your adjustments takes a few seconds. Wait until this process is
complete until you click
Transfer
to save the image.
N.B.
If you wish to view
your scanned images
press
Exit
. They will then
be displayed with their
original colour setting.
