5
English
Function selector
The function selector has 4 settings:
1. “
” Bubble function, heat and massage from the massage nubs and infrared
heat lamp.
2. “
” Bubble function and heat from the massage nubs.
3. “
” Massage from the massage nubs and infrared heat lamp. This function can
be used without water in the bath.
4. “0” OFF
Operating instructions
Note:
• Do not use the foot spa for more than 15–20 minutes at a time.
• Switch off and unplug the foot spa when it is not in use.
• The foot spa must only be used with water, no other liquids may be used.
• Do not add bubble bath or bath salt to the water.
• Never stand up in the foot bath, it is not designed to support the entire weight of a
person.
1. Place the foot spa on a stable, flat surface.
2. Fill the bath with water, either hot or cold.
Note:
Do not fill the bath to above the
MAX mark. The heating function can not heat up cold water. It can only provide a
little warmth for the feet.
3. Make sure that the function selector is set to “0” before plugging the foot spa into
a wall socket.
4. Sit on a chair, stool, sofa, etc and place your feet into the foot spa.
5. Set desired function using the function selector.
Emptying
1. Switch the foot spa off and dry your feet.
2. Make sure that your hands are dry and unplug the foot spa from the wall socket.
3. Tip the water out of the foot spa over the white edge.
Note:
Never pour water over
the function selector.
Care and maintenance
• Turn off and unplug the foot spa from the wall socket before cleaning it.
• Clean the foot spa with a soft damp cloth or sponge. Use only mild cleaning
agents, never solvents or corrosive chemicals.
• Always unplug the foot spa and store it in a dry, dust-free environment out of
children’s reach whenever it is not to be used for an extended period.
