12
English
Mirror
Flip
7. Scan framed slide (50 x 50 mm)
7.1 Basic setting when you start with the first image
Insert an SD memory card in the card reader (17). The memory card must be
formatted before you insert it.
1. Set both controls [ Film scanner - Photo scanner ] (9) and (15) to
Film scanner
.
2. Open the slide holder (3) and place the slide in the slide holder (see below).
3. Guide the slide holder into the feeder slot (18) with the white arrow first.
4. Switch on the scanner by pressing [
]; it will start after a few seconds.
5. “Capture” appears on the display.
6. Set which type of negative/slide is in
the slide holder.
-
Press [
►
] to move to
Film
.
-
Press [ ENTER ] and define the correct
kind of image by pressing [
◄
] or [
►
].
Choose from:
Slides
(colour slide) –
B&W
(black and white slide)
-
Press [ ENTER ] to confirm.
7. Guide the slide holder into the feeder slot until the whole of the first image appears
in the display.
8. Press [ SCAN ]; “Save” appears in the display. You can also select
Cancel
or
Home
.
Change by pressing [
◄
] or [
►
].
Or press [
►
] (turn image upside down).
NB:
The image mode can be changed
before scanning by pressing [
◄
]
(mirror image).
9. Press [ ENTER ] to scan the image; this takes about one second (the hour glass
disappears when it’s done).
10. Push in the film holder so that the next image appears in the display.
