7
English
unlock
lock
Use
Chuck
1. The hammer drill is fitted with
a keyless chuck (1.5–13 mm).
2. Hold the rear part of the chuck and
turn the front part anticlockwise until
the opening is big enough to accept
the drill bit.
3. Insert a drill bit or another tool.
4. Hold the rear part of the chuck and
turn the front part clockwise so that
the drill bit is gripped.
Note!
Do not attempt to tighten the chuck by holding the outer part of the chuck and
starting the drill, as this may result in an accident. Besides, the chuck locks better if
you hold the front and rear parts and tighten it by hand.
Side handle
1. Turn the side handle (4) anticlockwise
to unscrew it.
2. Set the side handle to the position
you want and set the depth stop if
necessary.
3. Turn the side handle clockwise to lock
both the handle and the depth stop.
Trigger switch
1. Connect the plug to a power socket
when you have fitted a tool to
the chuck and tightened it.
2. To start the hammer drill, slowly squeeze
the trigger switch (7). Check that the tool
is rotating in the right direction. To stop
the machine, release the trigger switch.
3. When the chuck is rotating you can
lock the trigger switch by pressing
the locking button (8) and releasing
the trigger.
4. To stop the drill, press and release
the trigger switch.
