OP 3241
PNEUMATIC SPRING COMPRESSOR 4T
INTRODUCTION
It is compulsory to read this instruction manual before starting any kind of action.
The proper operation and full compliance of this product’s performance is guaranteed only if all
the instructions provided in this manual are closely adhered to.
We guarantee that this product complies with the technical specifications described in this manual.
The manufacturer shall not be held responsible for any improper uses other than those described
herein.
Misuse:
• This product should only be used as described in this documentation; any other use is considered
improper.
• The manufacturer accepts no responsibility for any damage caused by the incorrect or
unreasonable use of the equipment.
• Moreover, misuse shall also void the warranty.
Take care of your tools:
• Be sure to store your tools in a clean state.
• Place the tools inside their original package.
Instructions and warnings :
The usage of this machine required a particular attention.
Compressed springs can be potential dangers due to force collected because of compression.
This machine must be used always with its specific frontal protection mounted correctly on the
frame.
Danger pictograms :
The machine is equipped with pictograms that show remaining risks and individual protection
measures to be used during working operations.
The pictograms are integral part of the product. In case of loss, deterioration or illegibility, require
the pictograms to the constructor in order to substitute them immediately.
Replace the pictograms always in the same place where they were removed following the above
design.
DESCRIPTION
The machine for assembling and disassembling shock absorbers is made up of a painted metal
tubular frame. On this structure is mounted a pneumatic cylinder fixed at the frame, its extension
and compression allows the compression and the release of the spring held by control brackets.
