This unit can be used to test the quality of brake
fl uid. It can indicate whether the brake fl uid
under test can still be used safely or needs to
be replaced. It is a very useful tool for ensuring
good braking eff ect and driving safely.
Before use, you sould perform adjustment to the
unit. The adjustment procedure is :
1 - Turn the test rod to make it stand up.
2 - Clean the test head and make it dry
NB : The test head consists of the two electric
poles and the short cylinder connecting with the
two electric poles.
3 - Insert the test head into the new brake oil
about 2cm deep, or expose the test head in
dry air directly.
NB : If you choose to use the new brake oil for
unit adjustment, this brake oil must be the same
type as the brake oil you want to test later.
4.
Press and hold down the "ON" button,
wait about 3 seconds, then use a suitable
screwdriver to adjust the adjustor. When the
fi rst green LED just lights and the other LEDs
are off , stop adjusting the adjustor. Now the
unit is ready to test.
NB : Don’t release the "ON" button until the
adjustment is fi nished.
NOTE :
1.
If LED (or LEDs) fl ashes or the buzzer
sounds when you press and hold down the
"ON" button with nothing being tested, the
battery is exhausted and should be replaced.
To replaced the battery, slide out the battery
cover, replace the exhausted battery with
a new one of the same type (9V, 6F22 or
equivalent). Reinstall the battery cover.
2. Each time before test, make adjustment to the
unit.
3. Do not use the unit if it’s damaged or has
malfunction.
1. Clean the test head (including two poles) and
make it dry.
2. Insert the test head into the brake oil to be
tested about 2cm deep.
3. Press and hold down the "ON" button, wait
about 3 seconds, then read the LED indication :
INSTRUCTION
ADJUSTMENT PROCEDURE
TEST PROCEDURE
INTRODUCTION
a - If the two green LEDs light, the quality of
the brake oil is good.
b - If the yellow LED lights, the quality of the
brake oil is bad.
c - If the red LED lights and the built-in
buzzer sounds, the quality of the brake oil is
unsafe to use.
BRAKE FLUID TESTER
AC 5006
Red LED
Yellow LED
The First
green LED
The second
green LED
"ON" bouton
Adjustor
Test rod
Electric pole
Test head
DISPOSAL OF THIS ARTICLE
Dear Custumer.
If you at some point intend to dispose of this
article, then please keep in mind that many of
its components consist of valuable materials,
wich can be recycled.
Please do not discharged it in the garbage bin,
but check with your local coucil for recycling
facilities in your area.
