CLAS CRIC ROULEUR 3T HAUTE ELEVATION, Quick Start Manual

OH 5311

HIGH ELEVATION HYDRAULIC FLOOR JACK 3T

CAUTION

1. Never adjust the setting valve.

2. Do not use on sloping ground.

3. Always use stands/ramps to secure the raised vehicle.

4. Check that the load is supported in the centre of the head.

5. Never exceed the maximum weight indicated 3T.

6. Any modification made to the product voids the guarantee and jeopardizes the safety of the 

user. No parts must be changed.

7. Only lift your vehicle in the areas recommended by the vehicle manufacturer.

8. Do not use in difficult conditions such as: extreme climate, application under frost, fields, etc.

powerful magnets, explosive atmosphere, mines...

9. If the jack fails, do not handle the jack any more and make sure you are not in danger.

10. Do not put the jack in direct contact with food.

11. In the event of oil spillage, clean up immediately to avoid any accident.

12. This appliance is designed for lifting vehicles only (not exceeding the indicated load).

do not lift dangerous materials such as molten metals, acids, radiating materials, fragile loads...do 

not lift people with the jack.

13. During any movement, it is important to have a good overall view of the lifting device and the 

load.

14. The use of special brackets is recommended to protect the vehicle.

15. When handling the jack, it is recommended to be equipped with appropriate clothing: gloves, 

safety shoes...

16. Do not work under the lifted load without securing it with appropriate means: jack stands, 

wedges...

USE

Lifting the jack

1. Place the jack under the vehicle at the level of the spaces provided for this purpose (see 

manufacturer’s manual).

Make sure that the head is well centred on the slots to avoid any slipping.

2. 2. Using the lever, tighten the safety valve to the right. Then move the lever up and down to raise 

the load. Lock the screw to allow lifting.

For your safety, once the vehicle is raised, remember to add candles underneath the vehicle.

Lowering the jack

1. Gradually turn the safety valve two turns from right to left.

2. Unlock the screw to allow the lifting arm to be lowered.

Do not unscrew the safety valve completely, as oil will escape!