EQ 3100
AUTOMATIC WHEEL BALANCER 3D VIDEO LASER POINTER
46
INSTALLATION AND SWITCHING ON
After unpacking wheel balancer, check the status of integrity and presence of faults, make the assembly of the
component sas shown in following pictures.
Electrical connection
The standard version of the machine must be connected to a mains 230V Single Phase.
The change of the power supply cannot be realized by the user; it must be requested to BRIGHT or to a dealer or
to an authorized service center. To accomplish the electric connection, connect the machine’s power supply cable
with the plug in use in the country.
ALL OPERATIONS TO MAKE ELECTRICAL CONNECTION AND INTERVENTIONS (HOWEVER LIGHT) ON
ELECTRICAL PARTS MUST BE CARRIED OUT BY QUALIFIED PERSONNEL.
The dimensioning of electrical connection must be carried out in according to electric power absorbed by the
machine. The absorption is specified in paragraph 10. The user must:
- Check that the supply voltage correspond to the voltage indicate on the nameplate of the machine;
- Check the conditions of the wire and the presence of the ground conductor;
- Check the machine is connected to its own electrical connection, fitted with a proper 30 mA sensitive automatic
circuit breaker, against a possible electrical overload over 30 mA;
- Connect the power supply cable to the plug with great care and following to the current regulations.
• WHEN THE MACHINE IS TURNED OFF FOR A LONG TIME IT IS NECESSARY TO DISCONNECT THE
POWER PLUG TO AVOID USE BY UNAUTHORIZED PERSONNEL.
IF THE MACHINE IS CONNECTED DIRECTLY TO THE POWER SUPPLY BY MEANS OF THE MAIN ELECTRICAL
BOARD AND WITHOUT THE USE OF A PLUG, INSTALL A KEY-OPERATED SWITCH TO RESCTRICT THE MACHINE
USE EXCLUSIVELY TO QUALIFIED PERSONNEL.
IN CASE OF OPERATIONS ON ELECTRIC PARTS, CABLES ENGINES OR ANY ELECTRIC DEVICES, IT IS
NECESSARY TO CUT OFF THE ELECTRICITY.
• DO NOT REMOVE, DAMAGE AND MAKE COMPLETELY ILLEGIBLE THE STICKERS OF DANGER, WARNING,
INSTRUCTIONS AND CAUTION. REPLACE ANY MISSING, DAMAGED OR ILLEGIBLE STICKERS. THE STICKERS
CAN BE FOUND AT THE NEAREST DEALER OF MANUFACTURER.
• THE DAMAGE FOR FAILURE TO COMPLY WITH THE ABOVE WRITTEN INSTRUCTIONS, IT WOULD BE NOT
CHARGED AGAINST THE MANUFACTURER AND IT MAY CAUSE THE INVALIDATION OF THE WARRANTY.
Summary of Contents for EQ 3100
Page 52: ...EQ 3100 AUTOMATIC WHEEL BALANCER 3D VIDEO DISPLAY LASER POINTER 52...
Page 53: ...EQ 3100 AUTOMATIC WHEEL BALANCER 3D VIDEO DISPLAY LASER POINTER 53...
Page 67: ...EQ 3100 AUTOMATIC WHEEL BALANCER 3D VIDEO DISPLAY LASER POINTER 67...
Page 69: ...EQ 3100 AUTOMATIC WHEEL BALANCER 3D VIDEO DISPLAY LASER POINTER 69...
