OE 1318
ELECTRIC ORBITAL SANDER 2.5mm Ø150mm
OPERATING INSTRUCTIONS
1. Connect the power cord of the sander to the power source (220V).
2. Press the ON/OFF button '
' to turn on the sander.
The LED indicator lights up in Fixed Green after the sander is switched
on.
3. Adjust the speed by pressing the '+' or '-' buttons.
Press '+' to increase the speed, '-' to decrease it.
The LED indicator changes to 'fl ashing red'.
It does not become fi xed when the motor reaches the maximum and
minimum speed.
4. Pull the trigger to start. Release to stop the tool.
5. Press the ON/OFF button '
' to turn off the sander.
STAND-BY
If the tool is in standby mode for more than 3 minutes, the machine will switch to STAND-BY/Off
mode. In STAND-BY mode, there will be no light on the LED indicator. The sander must be restarted.
ANOMALIES
An anomaly is indicated by the LED which lights up alternately Green/Red.
Please refer to the troubleshooting instructions to solve the problem.
SPEED ADJUSTMENT
This electric orbital sander has nine preset speeds (2,000 to 10,000 rpm).
The original starting speed is not the maximum speed when the tool was delivered.
The speed can be changed at any time while the sander is running or when it is running but not in
use and always in 'Run' mode.
Any maximum speed setting is stored: When the power is turned off , the setting will remain until
the next use.
SPEED CONTROL
1. The maximum speed is set by pressing the '+' or '-' buttons on the back of the sander.
While the sander is in 'Run' mode, each press increases or decreases the speed until the next setting
is reached.
2. In the default mode, the speed can be adjusted linearly by adjusting the trigger position.
SOFT START FUNCTION
The sander has a soft start function that prevents deterioration of the work surface.