OE 1318
ELECTRIC ORBITAL SANDER 2.5mm Ø150mm
Have your power tool repaired by a qualified repairer and use only original manufacturer’s
replacement parts. This will ensure that the safety of the power tool is maintained.
INDICATOR LIGHT INDICATOR LIGHT
There is an anomaly when the LED indicator displays the flashing color 'red and green'.
To find out about the anomaly, please follow the instructions below:
Press the '-' button for five seconds, the LED indicator will flash 'red' according to a code, refer
below to interpret it:
OTHER ISSUES
ISSUES AND RESOLUTION
Signal
Issues
Solutions
1 long - 1 short
Electric motor problem
Contact after-sales service
1 long - 2 short
Engine power supply problem
Contact after-sales service
1 long - 3 short
Overheating of the printed circuit
board
Stop and let the unit cool down. If the problem
persists, contact after-sales service
1 long - 4 short
Engine phase problem
Restart the sander. If the problem persists,
contact after-sales service
1 long - 5 short
Voltage too low
Check the supply voltage
1 long - 6 short
Voltage too high
Check the supply voltage
1 long - 7 short
Printed circuit board problem
Contact after-sales service
1 long - 8 short
Engine overheating
Stop and let the unit cool down. If the problem
persists, contact after-sales service
Issues
Solutions
No lights after switching on
Check the plug and voltage
Excessive vibration
Check the general condition of the tray
and change it if necessary
Excessive noise
Stop use immediately, carry out a visual
inspection and contact after-sales service
Trigger out of order.
Perform a product reset (see below)