OH 4550
BOTTLE JACK 50T
CHARACTERISTICS
- min. height: 265mm
- max. height: 425mm
- base: 210x176mm
- weight: 25kg
- lifetime: 300 times
- standards: CE 2006/42/EC & EN 1494:2000/A1:2008
SAFETY
These instructions have been written to help the user more eff ectively use and maintain the
jacks. Some of the information applying to construction, installation, operation, inspection, and
maintenance of hydraulic jacks was selected from EN1494:2000+A1:2008
Safety Precautions
WARNING: Failure to heed the following warnings can result in personal injury and/or equipment
damage. These warnings cannot cover every situation, so have safety foremost in your mind when
setting up a job.
• Read, understand, and follow the operating instructions, and the ANSI B30.1 and ASME PALD-1
safety standard for jacks.
• The operating instructions and safety precautions must be read and discussed in the operator’s
native language.
• Wear eye protection that meets the requirements of ANSI Z87.1 and OSHA.
• Inspect the jack before each use; do not use the jack if it is damaged, altered, or in poor condition.
• To prevent tipping, set up the jack on a hard, level surface. Set vehicle parking brake and block
tires.
• The load must not exceed the rated lifting capacity of the jack. Lift only dead weight.
• Center the load on the jack saddle, because off -center loads can damage seals and cause
hydraulic failure.
• Use the jack for lifting purpose only. This jack is designed to LIFT loads, NOT SUPPORT loads.
Immediately support a lifted load with jack stands.
• Stay clear of lifted loads.
• Use only approved hydraulic fl uid, such as Chevron AW Hydraulic Oil MV or equivalent.
