CLAS OH 5309, Manual

OH 5309

EXTRA FLAT ALUMINUM TROLLEY JACK 1.25T 85mm

3. Consult the vehicle owner’s manual to ascertain the location of jack points and position 

the jack beneath the prescibed lift point. 

4. Turn the release valve clockwise to the closed position. DO NOT OVER TIGHTEN.

5. To raise the vehicle to desirad height, place the handle into the socket and pump up and 

down.

6. Place jack stands beneath the vahicle at locations recommended by the vehicle 

manufacturer. Do not get under the vahicle without jack stands. Jacks are not designed to 

maintainheavy loads for log periods ot time.

7. Turn release valve SLOWLY counter clockwise to lower load onto jack stands.

Lowering vehicle:

1. Turn the release valve clockwise to the closed position.

2. Pump the handle to lift vehicle off of jack stands.

3. Remove the jack stands. Do not get under or let anyone else under the vehicle while 

lowering.

4. Turn the release valve SLOWLY counterclockwise to lower the vehicle onto the ground.

ASSEMBLY & MAINTENANCE

The product shall be maintained in accordance with the instruction manual. No alterations 

shall be made to this product.

1. Before use, a visual inspection of the jack should be made for abnormal conditions such 

as cracked welds, bent, worn, loose or missing parts, or hydraulic leaks.

2. The product shall be inspected immediately if the jack is believed to have been subject 

to an abnormal load or shock. It is recommended that the inspection is made by an 

authorized repair technician prior to use.

Assembly

Ensure that all parts are included:

• Jack chassis

• Pumping handle in 2 parts

Remove the retaining clip:

Press the handle yoke (11) down and then pull the retaining clip out from the hole in the 

base.

Handle assembly:

1. Assemble the handle by inserting the upper handle section (42) into the lower handle 

section (41) and firmly fix the upper handle  (42) and the lower handle (41) together by 

the spring button on the upper handle (42)

2. Remove the handle set screw (39) from the handle yoke and put pump handle into 

yoke socket hole, engaging the u-joint  of the release valve. Ensurethe handle is seated 

completely into the socket then tighten the handle set screw (39).

Maintenance

Monthly maintenance is recommended. Lubrication is important to jack as they support 

heavy loads. Any restriction due to dirt, rust, etc, can cause either slow movement or 

extremely rapid jerks, damaging the internal components. The following steps designedto 

keep the jack well lubricated.