OP 0307
PNEUMATIC FLOOR JACK 2T-3 STAGES
PACKING
- Place the jack so that the load is centred over it and where the
gripping points are indicated by the vehicle manufacturer. DWG. 4
- During lifting and lowering, it is necessary to check there are no
persons or animals under the suspended load or in the vicinity.
- Never lift loads on sloping, uneven or soft ground. DWG. 6
- If extensions are needed use only those supplied by the manufacturer with the jack.
Do not use extensions without the relevant plate. Never use more than two extensions.
- Do not lift the load in a confi ned space so as not to run the risk of getting trapped.
- It is forbidden to use more than one jack simultaneously on the same
load.
- Never tamper with the pressure relief valve that has the guarantee
seal. DWG.5
The body, handle and other parts of the jack are packed in a
three-layer corrugated cardboard box with pallet.
- The instruction “Keep upright” is clearly visible on the cardboard
box containing the jack.
- Either transpallets or forklift-trucks are used for handling.
