-5-
GENERAL CONNECTIONS
A.C. LINE
Making sure the power switch is in the off position; insert the linecord into the A.C. receptacle
on the rear of the unit.
CAUTION: SAFETY INSTRUCTIONS
DISCONNECT AC LINE CABLE WHILE MAKING ALL CONNECTIONS. "FLOATING THE GROUND”
OR DEFEATING THE GROUND ON A 3-PRONG LINECORD MAY CREATE A SHOCK HAZARD. CONNECT
ALL INTERCONNECT CABLES BETWEEN THE ELECTRONICS BEFORE CONNECTING THE A.C.
LINECORDS TO THE WALL OUTLETS. THIS WILL REDUCE THE POTENTIAL SHOCK HAZARD. SEE ALSO
THE 175-A WARRANTY SECTION OF THIS OWNER'S MANUAL.
STEREO
Check the setting on the STEREO/MONO toggle switch, located above the input jacks on the
back of the unit. The lever should be closest to the position marked STEREO.
Input and output connectors are clearly marked on the back of the amplifier. Left/Right
connections are oriented from the front of the unit. Stereo output connections are marked above the
connectors.
Use only high quality interconnect and loudspeaker cables, and make all connections tight. If the
input plugs are loose, remove them and pinch down the ground leaves slightly with pliers. Tighten the
output bolts with the nut driver supplied, placing the wire or lug between the washer and large chassis
nut. Observe correct phasing of the loudspeaker connections.
