21
Connect the Main L&R Outputs, either RCA or XLR, from the rear panel of
the CP-800 to the corresponding inputs on your amplifier(s).
• If you are using a subwoofer, connect the CP-800 subwoofer output
to the input of the designated amplifier or powered subwoofer.
NOTE: Make sure connections from the subwoofer output go
only
to
an amplifier connected to a subwoofer or a powered subwoofer, as low
frequency signals can damage a small speaker not designed for high output
bass reproduction.
When connecting a cable, make sure the cable has a good connection and is
firmly attached to the rear panel connectors on both the amplifier and the
CP-800.
The CP-800 also provides two
Auxiliary
analog audio outputs. See the section
on Configuration Setup for more details about the Auxiliary outputs. If used,
connect the AUX output(s) to its corresponding amplifier(s) or subwoofer.
Step 5
Connect the loudspeakers to the amplifiers.
Important!
Verify that the power amplifier(s) is plugged in but powered
OFF before connecting to the CP-800.
Connect each loudspeaker to its designated amplifier channel. Pay close
attention to the phase of the speaker connections
– always connect an amplifier’s
red (+) terminals to the red (+) terminals of the loudspeaker. Likewise, connect black
(–) terminals to black (–) terminals.
Step 6
Power up the system!
Now you are ready to power up your CP-800 and your audio system.
• Turn the rear panel power switch of the CP-800 to
ON
. The Standby
LED will turn red.
• Press the standby button located next to the LED.
The initial power-
up cycle of the CP-800 takes a few seconds.
• When the power-up cycle is complete, the CP-800 enters Operate
mode and the touchscreen becomes active.
• Press the
Standby
button to toggle the CP-800 into and out of
Standby.
The physical setup of the CP-800 and system components is complete.
Summary of Contents for CP-800
Page 1: ...Owner s Manual CP 800 Stereo Preamp Processor ...
Page 51: ...51 Dimensions ...
Page 53: ......