CA-301 ISSUE 1 MAY ‘99
-
8
-
CONNECTIONS FOR REGULAR OR BALANCED INPUTS:
The
CLASSÉ
P-303
power amplifier is equipped with both regular and balanced inputs.
Either one may be used
SEPARATELY, BUT NOT SIMULTANEOUSLY
. The balanced inputs must be
connected to a preamplifier which has balanced main outputs. Balanced interconnects with
"XLR"
connectors are also required. Regardless of the amplifier inputs used, stereo or mono operation is
possible on the
P-303
.
REGULAR INPUTS
Engage
the
REGULAR/BALANCED
switch to the position marked
"REGULAR"
. (The amplifier is
factory set for “
REGULAR”.
)
NOTE:
The
REGULAR/ BALANCED
switch will not operate if the
amplifier is turned on; you will NOT be able to change from one mode to the other, as the mode is
“locked” while the amplifier is on. To activate the circuit, turn off the unit and engage the
REGULAR/BALANCED
switch to
REGULAR.
If the unit has not been turned off before engaging the
switch, turn off the unit, wait for about 10 seconds, and turn the unit on again, the circuit will then
engage. Connect the regular interconnects to the
RCA
input jacks on the rear panels of the
P-303
. The
balanced connectors are automatically disabled.
BALANCED INPUTS
Switch
the
REGULAR/BALANCED
switch to the position marked
"BALANCED".
A balanced
preamplifier and balanced interconnects are also required. NOTE: The
REGULAR/ BALANCED
switch
will not operate if the amplifier is turned on; you will NOT be able to change from one mode to the
other, as the mode is “locked” while the amplifier is on. If the unit has not been turned off before
engaging the switch, turn off the unit, wait for about 10 seconds, and turn the unit on
