13
12. Insert the foot pegs.
Insert the foot pegs into the pontoon frame as shown. Starting with a position in
the middle of the adjustment range, align the holes and secure with two clevis pins.
8. Attach the seat frame to the pontoon frames.
Insert the seat platform tubes onto the pontoon frame posts with
the seat facing the front. The front of the pontoon frames are the
ends labeled “L” (left) and “R” (right). (You may need to LIGHTLY
tap the frames with a rubber mallet to fit).
Align the holes and secure with four clevis pins.
You MUST lock the security retainers on all four clevis pins to
insure that the frame stays together.
9. Thread the anchor bag cord.
Start by feeding the cord into the
front anchor cord pulley located on
the side of either pontoon frame.
Continue by threading the cord
through the cord guides and under
all frame tubes.
Next, insert the cord through the
rear cord tube guide [1] on the rear
platform frame. Finish by threading
the cord through the pulley mounted
on the rear platform frame and
attaching the cord to the anchor bag.
11. Insert the oar locks.
Insert an oar lock into the top of both oar lock brackets on the pontoon frames. There are three
oar lock positions; we suggest starting with the forward most position. If you have the seat set
back you may prefer the middle or back position. Secure each oar lock with an oar lock clevis pin.
10. Attach the rear platform frame.
In order to attach the rear platform frame you
must first partially attach the wire cargo deck.
Start by sliding the bent wire tabs into the slots
welded on to the rear of each pontoon frame.
Next, push the rear platform frame tubes into the
open tubes on the rear of each pontoon frame.
Make sure to insert the wire guides on the rear of
the wire cargo deck into the corresponding holes
on the rear platform frame as you push the tubes together. Also make sure not to pinch the threaded anchor cord.
Attach the rear corners with two clevis pins. These secure the wire cargo deck and the rear platform frame to the pontoon
frames. Be sure to insert each pin through the cargo deck, the rear platform frame and through the pontoon frames. Lock
both clevis pins.
Motor mount can
be mounted to
either side
1
Attach this
end of anchor
line to the
anchor bag
Note: Seat and p0ntoons
removed for clarity
Note: The anchor bracket can be placed
on either side of the rear platform frame.
Insert the included ball-end wrench into
the bottom of the anchor stud while
holding the nut on top of the stud with
an adjustable wrench
to loosen.
Front anchor
cord pulley
C O L O R A D O X T P O N T O O N B O A T O W N E R ’ S M A N U A L
Meijer.com
