background image

Instructions: 

Golf Car Enclosures

DO NOT 

MACHINE 

WASH

MILD SOAP

FOR 

WINDOWS

ONLY

DO NOT 

MACHINE 

WASH

MILD SOAP 

FOR 

WINDOWS 

ONLY

DO NOT 

PACK WET 

NO TOOLS

REQUIRED

LINE DRY 

Installation

1. Identify the front of your Golf Car enclosure by locating the interior

yellow tag which reads "FRONT".  Drape the enclosure over the roof of 

your golf car with the zippered panel at the back.

2. Pull the cover from front to back onto the roof. Make sure the roof

edges line up with the seams.

3.  Zip the side and rear panels down over the car.
4. Attach the elastic hooked straps along the sides of the golf car.

See figure 1.

5. The side doors open with zippers. To keep the doors open fold in half

and snap secure. Roll the doors to the back and fasten them with the

provided rip-and-grip straps. See figure 2.

6. If your enclosure has removable doors (all but the travel enclosure),

hold zipper and door and firmly pull horizontally apart as shown in

figure 3.

7. There is a zippered opening in the back so you can easily load and

unload your golf clubs. If your enclosure has a zippered rear panel it

can be rolled all the way up to the roof and secured with rip-and-grip

straps. The Yamaha

®

, E-Z-GO

®

, & Club Car Precedent

®

 model specific

enclosures can be secured at the halfway point as well.

8. If your enclosure has a removeable windshield you can completely

unzip the windshield. The Yamaha

®

, E-Z-GO

®

, & Club Car Precedent

®

model specific enclosures have a front hideaway pocket where you can

store your windshield when not in use. See figure 4.

Cleanning

Clean your enclosure with a soft brush and lukewarm water. DO NOT USE 

SOAP as it may remove the protective coatings. Line dry.
Tip: If the clear vinyl windows on your cover are wrinkled from storage 

you can smooth them out with a hair dryer. Be sure to set the dryer on 

low and hold it at an appropriate distance.
Tip: Clean clear vinyl windows with mild soap using your hands or a soft 

cloth to avoid scratching the surface.

1

2

3

4

Rear zippered entry for golf clubs works well 

with rear canopies

Driver and passenger doors can be rolled to the 

side and held open with straps (doors are shown 

closed in this photo)

Each side zips for easy door entry and exit

Hooked straps along each side secure 

cover to car for a custom fit  

WARNING

Make sure your enclosure is on properly and 

securely fastened before operating your golf car.

 WARNING 

Enclosures do NOT protect against noise, engine 

exhaust, chemicals, collision, roll-over or other 

accidents.

 WARNING 

When your golf car is at idle with your enclosure 

installed, make sure to open a side door to ensure 

proper ventilation against carbon monoxide.

Storage

A handy storage bag is 

provided to store your 

enclosure in. To avoid 

mildew, be sure the 

enclosue is completely 

dry before you store it in 

the storage bag. 

Reviews: