Classic Smart 4F, Owner'S Manual

GB

5

USER INSTRUCTIONS

Classic 

smart 4F 

Universal Remote Control

INSERTING THE BATTERIES

Your new 

smart 4F 

remote control uses 2 LR03 or AAA Alkaline batteries which

must be installed before it can be used. Always use new batteries of the same

type and install the two new batteries the correct way round as shown by the

battery markings in the battery compartment on the back of the remote control.

Please dispose of used batteries as advised by the battery manufacturer.

SETTING UP YOUR 

smart 4F

Your 

smart 4F 

can control 4 devices. TV, VCR, SAT and DVD which can be set up

by entering either a 3 digit code from the code list included in your instruction

book or by using the library search facility. Instructions for both methods follow.

SET UP BY ENTERING A 3 DIGIT DEVICE CODE

Refer to the device code list in your instruction book and look up the 3 digit code

which corresponds to the brand of the device you wish to control. If there is more

than one code listed against the brand start with the first code. 

Make a note of the code and follow steps 1) to 6) below.

1) Switch on the device you wish to control (e.g. your TV)

2) Press and hold down the required device key on the 

smart 4F 

(e.g. TV)

    and at the same time press and hold down the OK key.  Keep both keys pressed

    down for approximately 5 seconds until the indicator light on the device key 

    being held down lights and remains on. Release both keys.

3) Use the number keys on the handset to enter the 3 digit code you found in

    the code list.

4) The indicator will blink.

5) Press and release the device mode key (TV in this example)and the

    indicator will blink 3 times. This indicates that you have now stored the code

    into the handset.

6)Try all of the functions of the remote control.

7) If your device does not respond or responds incorrectly to the commands

    repeat steps 1) to 6) using the next number you found against your brand in

    the code list.

    If the device key does not blink 3 times at step 5 an incorrect code has been

    entered. Check for the correct 3 digit code for your device in the code table

    and repeat steps 1) to 6).

    Repeat the above procedure to enter the codes for your VCR, SAT and DVD

    using the appropriate device key on the 

smart 4F

 and code from the device

    code list.

    Make a note of the device codes used on the label inside the battery

    compartment should these be needed again in the future.

smart4F.indd   5

23.09.2008   17:10:40 Uhr