I N S TA L L AT I O N I N S T R U C T I O N S
Position your completed Wood Mantel close to its final location. Make sure you can access the back of the
Fireplace, your Electric Fireplace Insert will be installed from the back.
Using a Phillips head screwdriver remove the screws and the mounting brackets attached on either side of the fire-
places center opening. Next unpack the Electric Fireplace Insert carefully. Position insert behind fireplace with front
facing the wood mantel. With the help of an adult assistant, lift the Insert and gently slide it into the opening in the
mantel until the flange is flush against the inside of the fireplace. Make sure insert is centered left and right in the
opening.
Be careful when placing insert and
adjusting, bottom of insert could scratch the
finish of the wood base/hearth of your fire-
place.
Re-attach the mounting brackets with
the Phillips head screwdriver, and supplied
screws. DO NOT OVER TIGHTEN.
With the help of an assistant carefully lift
completed unit and place it with the front
facing out in the final location you have
chosen for your fireplace. Make sure to
secure the electrical chord before lifting or
moving completed fireplace. When choosing
a final location make sure you will have clear
access to a grounded electrical outlet.
Read and follow all instructions in this
manual before operating your new fireplace.
BACK VIEW
FIREPLACE
INSERT
FIREPLACE
INSERT
BRACKET
PA R T S L I S T
Part Number
Description
E200200 . . . . . . . . . . . .Ember Bed/Log Grate/Logs
E200300 . . . . . . . . . . . .1,500 Watt Heater
E200301 . . . . . . . . . . . .Cylindrical Fan
E200400 . . . . . . . . . . . .Master On/Off Switch
E200401 . . . . . . . . . . . .Knob for Brightness Control
E200402 . . . . . . . . . . . .Heater On/Off Switch
E200403 . . . . . . . . . . . .High Heat On/Off switch
E200404 . . . . . . . . . . . .Knob for Heater Temperature Control
E200500 . . . . . . . . . . . .E-12 Light Bulb sockets
E200502 . . . . . . . . . . . .Front Projection Screen
E200503 . . . . . . . . . . . .Frosted Mylar Projection Screen (Rear)
E200504 . . . . . . . . . . . .Sheet metal Flame Cut-out Screen
E200505 . . . . . . . . . . . .Flame Generator/Spinner
E200506 . . . . . . . . . . . .Flame Generator Drive Motor
E200509 . . . . . . . . . . . .Angled Reflection Hood
E200603 . . . . . . . . . . . .Assembly Instructions/Warranty
