12
Installing your rangehood
IMPORTANT:
You will have to decide before installing your rangehood whether to use it
in extraction mode or recirculation mode. Please refer to page 14 to understand the
differences between these two modes.
o
We recommend that at least two people install this rangehood.
o
If you are using the appliance in recirculation mode, then PLEASE NOTE that all
of the vent in the upper chimney section must be exposed. You will have to take
this into account when calculating the minimum height of the extractor when
installed.
o
IMPORTANT: If the recirculation vents are obstructed then the efficiency of
the extraction will be affected and could damage the motor.
IMPORTANT: YOUR RANGEHOOD SHOULD BE CONNECTED TO YOUR MAINS
SUPPLY AFTER THE REST OF THE INSTALLATION PROCESS HAS BEEN
COMPLETED.
1) The cooker hood should be placed at a distance of 65-75cm (26-30inch) from the
cooking surface for the best effect.
2) Drill a hole in the cupboard, 490mm*265mm. Make sure the distance between
the edge of the hole and the edge of the cupboard edge is at least 35mm.
3) Take down the filter and remove the four screws on the panel.
4) Use eight ST4 x 18mm screws to fix the hood into cabinet.
5) Fix the panel back to the body and equip the filter.
6) Connect the ducting pipe to the outlet.
Summary of Contents for CLPP52L
Page 19: ......
