SPM3754_IM
07.01.20
27
1. Press the switch in order to turn the appliance on.
2. Use the middle brush for pre-cleaning, i.e. to remove dirt
and dust from the surface of the shoes.
3. To apply shoe polish to the shoes, gently press the shoe
against the ball located in the closure of the polishing
dispenser.
4. Use one of the two brushes on the side for polishing the
shoe.
NOTE:
Make sure to
always
use one polishing brush for light
and the other one for dark shoes.
5. Use the switch to turn the appliance off.
Cleaning / Maintenance
WARNING
:
• Always pull the plug before cleaning and maintenance.
• Wait until the appliance has cooled down.
• Never immerse the appliance in water. It could result in an elec-
tric shock or fire.
CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
Rubber Mat
Remove the rubber mat. Then clean it by knocking it out or
vacuuming it. In the case of coarse soiling, you may clean
it thoroughly in a rinsing bath. Let the rubber mat dry com-
pletely before putting it back into the appliance.
Bracket, Polishing Dispenser, Closure
Clean these components in a rinsing bath. Allow the compo-
nents to dry completely before refitting them.
Housing
Use a slightly damp cloth to clean the housing.
Replacing the Brushes
In order to replace the brushes, proceed as follows:
1. Use a screwdriver
to loosen the screws
(see adjacent
figure).
2. Slide the brushes off
the driving shaft.
3. Attach the new brushes by applying the same order in
reverse.
Troubleshooting
Problem
Possible Cause
Remedy
The
appliance
is not
working.
The appliance has
no power supply.
Check the socket with
another appliance.
Plug in the mains plug
correctly.
Check the main circuit
breaker.
The appliance is
defective.
Contact our service or
a repair centre.
The overheating
protection has been
activated. The motor
is too hot.
Let the appliance
cool down for at least
15 minutes before
switching it on again.
Technical Data
Model:.....................................................................SPM 3754
Power supply:....................................................230 V~, 50 Hz
Power consumption: .....................................................120 W
Protection class: .....................................................................
Net weight: ....................................................... approx. 6.6 kg
The right to make technical and design modifications in
the course of continuous product development remains
reserved.
This appliance has been tested according to all relevant
current CE guidelines, such as electromagnetic compatibility
and low voltage directives, and is manufactured according
to the latest safety regulations.
Summary of Contents for SPM 3754
