Switch
Command to enter
Resulting prompt
Base eithernet
base-ethernet
ATCA-2210-Base#
Fabric ethernet
fabric-ethernet
ATCA-2210-Fabric#
3.
Enter this command to show the status of the ports.
show port all
View the status information of the ports to see which ports are enabled. If needed, press the
space bar to view more of the list.
4.
Proceed to the applicable section or step:
a.
To enable all ports, see
Enable all ports
below.
b.
To enable only specific ports, see
Enable specific ports
below.
c.
To leave all ports disabled, continue to the next step.
5.
To return to the ATCA-2210# prompt, enter the command:
exit
If you are asked to save changes, enter y for yes or n for no. If you choose yes, this
configuration will be saved as the startup configuration.
6.
To log off from the SFB, enter the command:
exit
7.
If you have two SFBs installed, repeat these steps for the other SFB.
Enable All Ports
1.
Verify you are at the applicable switch prompt.
Switch
Prompt
Base eithernet
ATCA-2210-Base#
Fabric ethernet
ATCA-2210-Fabric#
If you are not at the appropriate prompt, see
View port status
above for instructions on how to
get there.
2.
Enter this series of commands to enable all ports:
configure
no shutdown all
spanning-tree port mode all
spanning-tree
exit
telnetcon timeout 60
copy system:running-config nvram:startup-config
This operation may take a few minutes. Management interfaces will not be available during
this time. When you are asked to save changes, enter y for yes or n for no. If you choose yes,
this configuration will be saved as the startup configuration.
Chapter 6: SF6090 Switch Fabric Blade
Installation
22