Starting CorePlus
TM
a) The console will indicate that it is
Generating Base Configuration
and
when this is complete it will say
Done
.
Now press ”Y” to start the Clavister CorePlus
operating system.
7
Choose an Interface
The console should now show a menu for
selection of the interface for the management
workstation.
Choose the management interface from the
menu that was connected up previously in
step 2 and press the Return key.
Enter IP address & Default Gateway
The console will now allow a number of
options to be entered. Enter the IP address that
will be used for the management interface of
the SG3200 with the appropriate netmask.
If the SG3200 is not on the same network as
the FineTune management workstation (and
is therefore at least one router hop away) you
will also need to specify the Gateway Address
and the Allowed Management Network with
it’s netmask.
If you want to allow FineTune management
access from any network, specify the Allowed
Management Network as 0.0.0.0 with Netmask
0.0.0.0. However restricting access to a specific
network (or IP address) is recommended and
this can be done at a later time with FineTune.
Press Ctrl-S to save the settings and continue.
5
6
SG3200 Quick Start Guide
b) If everything is correctly configured,
CorePlus will start and you will see a
console screen similar to the one below