1. SAFETY INSTRUCTIONS
Carefully read these instructions before starting the pump.
For safety reasons, persons who have not read the instructions shall not be authorised to
use the pump. A drainage pump is an electrical appliance and needs due care and
responsibility when operating. The power cable should never be used to transport or shift
the pump. Always use the handle of the pump for these operations.
The pump cannot be used to pump salty water, sewage, inflammable, corrosive or
explosive liquids (i.e. petrol, fuel, diluents), grease, oils or food stuff.
In case power cable is damaged, to avoid any risk, replacement must be done by the
manufacturer of the pump or by an authorised service centre.
Never remove the plug by pulling on the power cord.
Before handling the pump always remove the plug from the power socket.
Before starting the pump, verify that:
• The electric system is equipped with a Residual Current Device (RCD) with a rated
residual operating correct of no greater than 30 mA.
• The voltage and frequency shown (240V/50Hz) on the technical nameplate of the pump
correspond to the data of the electric supply system.
• The power cable of the pump is not damaged
• The electric connection is done in a dry area at a safe distance from possible flooding.
• Pump is suited for application: grey water / clean water , pressure requirements etc.
6. MAINTENANCE AND CLEANING
7. WARRANTY POLICY
Before doing any maintenance on the pump, always remove the plug from the power
supply.
Wear protective cloths when doing any maintenance work, gloves, protective eye wear
etc.
Periodically, it is advisable to make sure that no dirt, leaves sand etc. has accumulated in
the collection pit.
It is absolutely necessary to protect pump from freezing. If the temperature falls below
the freezing point, remove the pump from the liquid and store it in a safe place where it
cannot freeze.
Clayton Engineering warrant this product for 2 years from the date of purchase. The
warranty covers manufacturer’s defects in material or workmanship. The warranty does
not cover malfunctions due to misuse or due to failure to follow the instructions in the
instruction manual. Any alterations to the product are to be performed by a Clayton
Engineering approved service agent. Any repairs performed by non approved personnel
may void the warranty.
To make a claim, contact Clayton Engineering, 26 French Ave, Brendale, Q, 4500 on
phone 1300 798 022 or email sales@claytonengineering.com.au. You will be asked to
provide proof of purchase and then will be instructed on the procedure for repairing or
replacement of the product under warranty. All costs incurred for repair or replace, and
additional claims can be discussed at this stage.
This warranty is provided in addition to other rights and remedies you have under law:
Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law. You are entitled to a replacement or refund for a major failure and for
compensation for any other reasonably foreseeable loss or damage. You are also entitled
to have the goods repaired or replaced if the goods fail to be of acceptable quality and
the failure does not amount to a major failure.
1st January 2012.
