5.1 Load search mode
• In cases where it is preferable to leave the combi switched on, and the load is periodically inactive
(switched OFF) the load search mode can be activated.
In this mode the combi is partly active and generate a short pulse every 2 second, if a load (>10W resistive)
is detected the device switch ON automatically. When a load is disconnected again the device automatically
returns to search mode (low consumption) after 1 min without load
• In load search mode the battery consumption is reduced to less than 3W in order to save the battery during
no load periods!
Activate load search mode
• Switch OFF if the combi (if activated)
• Push down the power switch for > 5 seconds
• Release only when the
blue, green and red LED starts to light at the same time
.
Note: in load search mode the battery consumption is reduced, while no load is active! The device switch on
automatically when a load is connected (> 10W resistive)
The load search mode will remain active, until deactivation or disconnection of the battery (the mode will be
active > 15min after disconnecting the battery)
Note: there will be a small delay when connecting a load and until the device starts up automatically!
Note: If load search mode is entered with a load connected, the blue LED flashes slowly only for 5 seconds
(to indicate entering of load search mode), then it lights continually!
Note: When a load has been connected and afterwards disconnected the device stays fully ON for 1 min
then it returns again to search mode (low battery consumption).
Deactivate load search mode
• Push power switch > 5 seconds.
• Release only when
Blue, green and red LED start to flash at the same time.
Remote used with load search function
• The load search function will remain active if the device is switched ON and OFF by remote.
• Only deactivation (or disconnection of battery >15 min) will clear load search mode
