10
Self-learning Start Voltage
Start Voltage controls when the LPS II starts charging from the connected solar panels. If the
setting is not changed, the LPS II unit will find the most optimal setting itself.
Press "OK" to go to menu - Select "Solar" - Select "Self-learning Start Voltage" and press "OK".
Use the arrows in the Self-learning Start Voltage window to change the maximum number of volts
from 0.00V to 50V. Press "OK" to activate the selected option.
Menu: General
Status:
Battery status:
Energy meter:
Temperature:
I/O voltage:
Functions:
Error codes
Display
About
Battery Status
The Battery Status category shows a snapshot picture of device status and performance.
Operation Status Standby:
Standby/On
Remaining Operation:
Time remaining with current load
Current Capacity:
Percent
Power:
W (Watt)
Voltage:
V (Volt)
Current:
A (Amps)
Temperature:
0C (Celsius)
Cell 1:
V (Volt)
Cell 2:
V (Volt)
Cell 3:
V (Volt)
Cell 4:
V (Volt)
Number of cycles:
#Amount
Energy Meter
Under the Energy Meter category, you can see how many kWh have been charged through the 4
terminals.
230VAC Charging:
kWh
kilowatt hours
DC Charging:
kWh
kilowatt hours
DC Output/Super Charge:
kWh
kilowatt hours
Solar:
kWh
kilowatt hours
11
