13
About
The "About" menu contains basic information on your LPS II device.
Press "OK" to go to menu - Select "General" - Select "About".
The information is as follows:
Serial Number:
30XXXX-1234
Manufactured:
2021-01-01
Hardware version:
30:00
Firmware version - Unit:
01:30:30
Firmware version - Display:
01:04:07
Firmware version - Power Board:
91:00:07
Firmware version - DC-DC:
01:00:30
Service - QR Code
A QR code can be scanned in the Service category that will take you directly to Clayton Power's
service page. On the service page, you will find all manuals as well as tips and tricks for different
installations and uses.
Operation via Remote
Charging
It is possible to read if the device is charging and from which source. This is by a diode lighting up
from one of the three charging options (230V, 12V, 12V Boost).
Power ON/OFF
To activate the LPS II, press the desired voltage, 230V/12V, or both. On correct start-up, a green
diode will light according to the selected voltage.
Jump start
Activate jump start by pressing the button, after which a green LED will flash. After about 4
minutes it will be possible to start the vehicle.
Battery status
The LPS II battery level can be read from the remote control. Battery level is indicated by 5 LEDs,
which show how much power is left in the battery.
