Set Operation
The C2 terminal on the LPS II unit is a multifunctional terminal which includes solar charging. You
can therefore choose under "Set Operation" whether the LPS unit itself should control what it
detects (Auto), search for solar panels only (OK) or other functions (Off).
Press "OK" to go to menu - Select "Solar" - Select "Set Operation" and press "OK".
Use the arrows to choose between Auto, Off or On in the Set Operation window. Press "OK" to
activate the selected option.
To reset all solar parameters back to factory settings, set "Set Operation" to "Off". All parameters
will switch back to 15V.
If you change solar setup, we recommend that you restore factory settings before reconnecting to
the LPS II.
Self-learning OC Voltage
OC Voltage stands for Open Circuit Voltage, which is the maximum voltage a solar panel can
deliver without load. The LSP II unit will find this point itself if you do not want to enter a value.
Press "OK" to go to menu - Select "Solar" - Select "Self-learning OC Voltage" and press "OK".
Use the arrows in the Self-learning OC Voltage window to change the maximum number of volts
from 15V to 50V. Press "OK" to activate the selected option.
Self-learning MPPT Voltage
MPPT stands for Maximum Power Point Tracking. This means the device can find the most optimal
setting to charge most efficiently. It is possible to set this parameter manually.
Press "OK" to go to menu - Select "Solar" - Select " Self-learning MPPT Voltage" and press "OK".
Use the arrows in the Self-learning MPPT Voltage window to change the number of volts from
0.00V to 50V. Press "OK" to activate the selected option.
Menu: Solar
Status:
Operation status: On/Off
Power:
(W)att
Voltage: (V)olt
Current: (A)mps
Functions:
Set Operation:
ON/OFF
Self-learning OC Voltage:
(V)olt
Self-learning MPPT Voltage: (V)olt
Self-learning Start Voltage:
(V)olt
9
