BAG FILTER CHANGE
If this vacuum is used to collect hazardous material, appropriate personal protective equipment may be required.
The bag filter should be replaced then ¾ full
1. Safe the Vacuum
• Disconnect the Vacuum from power source
2. Remove the Power Head
• Unlatch the Power Head from the tank
• Lift the Power Head and attached HEPA filter off the tank by the top handle
• Carefully sit the Power Head on the floor - avoid damaging the HEPA filter
3. Remove the Filter Bag
• Grasp the cardboard collar of the bag filter and slide it off the inlet
• Holding your hand over the opening on the bag, lift the bag out of the tank
• Dispose of the bag according to your company policy
4. Install a Filter Bag
• Unfold and fluff a new Filter Bag
• Push the inlet tube into the hole on the cardboard collar of the Filter Bag
• Grasp the sides of the cardboard collar and push it all the way on to the inlet tube
• Ensure the bottom of the collar is past the opening on the underside of the inlet tube
5. Ensure the HEPA Filter is sealed
• Holding the power head on its side, look at the HEPA Filter
• Ensure the white inner ring of the HEPA Filter is in contact with the underside of the power head
• If it is not, turn it clockwise until it comes in contact with the underside of the power head
6. Replace the Power Head
• Sit the Power Head on the tank
• Rotate the Power Head so that the switch on the Power Head is in line with the inlet port on the vacuum tank
• Latch the Power Head to the tank
Repair or Warranty Contact
Clayton Associates, Inc.
•
1650 Oak Street
•
Lakewood, New Jersey 08701
•
P.+1-732-363-2100 F.+1-732-364-6084
www.DustlessMadeSimple.com
•
Sales@JClayton.com
Page 6
BEFORE EACH USE
1. Attach the Vacuum Hose
Vacuum Hose only
• Open the Vacuum Inlet
• Insert the metal sleeve of the vacuum hose into the inlet on the vacuum
2. Activating the Vacuum
• Toggle the Power Switch to the ON Position.
