[H]
[G]
9
4 . Once holes are drilled, remove tape and
mounting template and save template
with your instructions in case you move
or wish to remount at a later time .
5 . Wipe dust and debris off inside cabinet
surface . Also, make sure under side of
cabinet is clean .
6 . Place a washer inside the cabinet over each of the 4 holes you drilled .
7 . Now, use your ruler or the paper ruler provided to measure the overhang height, placing
your ruler vertically against the underside of the cabinet behind the overhang
[G]
. If this
measurement is less than 1-3/4”, you may skip step 9 . If it is greater than 1-3/4”, this number
determines the number of spacers you need, using the SPACER MOUNTING GUIDE
found below .
8 . Drop one of your screws through each
of the washers covering the holes in the
cabinet, from inside the cabinet down .
9 . Place the appropriate number of spacers
determined in step 7 on each screw
so the appliance will be even with the
front overhang
[H]
.
NOTE
: For spacer installation, you may require assistance (in mounting) in order to hold
spacers in place while securing the appliance at the same time. If assistance is not avail-
able, use pieces of tape to hold the spacers in place while you position the appliance.
SPACER MOUNTING GUIDE
MEASUREMENT SPACER
1-3/4” or less
None
1-13/16”
1/16”
1-15/16”
3/16”
MEASUREMENT SPACER
2”
1/4”
2-1/16”
1/4” + 1/16”
2-3/16”
1/4” + 3/16”
