BLX-200W Manual Page 6 of 9
Updated: 02/11/21
USER MANUAL: BLX-200W
READ ALL INSTRUCTIONS BEFORE OPERATING EQUIPMENT
Installation (continued)
Fig. 6.1: Water line of BLX-200W
Fig. 6.2:
Brush clip rotation for brush removal
Removing Brushes
1.
The brushes are held in place by the brush clip at
the front of the unit.
2. To remove the brushes, pull up on the clip and
twist them outward, as shown in [Figure 5.2].
3. Once unlocked, the brushes can be removed for
cleaning, by slipping them out from their holders.
Plumbing (continued)
3.
Using the push to connect fitting, connect the
Venturi system to the BLX's water line located
under the unit, near one of the foot plates
[Figure 6.1].
4.
Test the system by stepping on the footplate to
engage the unit and begin spraying.
5.
Adjust the solution output as necessary using the
included metering tips (instructions included).
NOTE:
Injector must be mounted within 10 ft.
of boot scrubber.
!
WARNING:
DO NOT use flammable liquids (i.e. alcohol
based solutions or similar) without dilution.
