13
Figure 3.4.8: Remove Sensor Figure 3.4.9: Sensor bracket screws Figure 3.4.10: Threaded rod removed
•
Select replacement jaw set and assemble them in the reverse order of operations.
•
Note: If the cylinder shaft won’t retract when being cycled the adjustment of both
set screws on the front cylinder mount bracket will need to be adjusted. To make the
adjustment you must first loosen the two 5x12mm screws using a 3mm hex wrench
(Figure 3.4.11) and then by adjusting the two set screws using a 3/32
nd
hex wrench.
Figure 3.4.12. Now tighten the two 5x12mm screws and ensure jaw alignment.
5x12 mm screws (One per side) Set Screw (One per side)
Figure 3.4.11
Figure 3.4.12
4.0
Troubleshooting
Operating Error
Action
Unit does not operate.
1.
Check the facility air connection.
2.
Check all air hose connections on the unit.
