CLEAN ROOM DEVICES CRD610, Operation Manual

  11 



Close the Cover on the CRD610 and tighten the six button head screws on each side 
using a 3mm hex wrench. 

Notice:  It is not recommended to operate the 

CRD610

with the cover open. 

             2.6      Magazine Installation 
 



Select the appropriate magazine that corresponds to the fitting being installed.



Slide the fittings into the slot on the magazine so that the barbed end (the end you will  

insert into the tube) is protruding.  Put enough parts into the magazine to fill it.   
 



Always have at least five fittings in the magazine or a jam may occur.



Place the magazine into the magazine rack with the parts facing the jaw set. 



Check to see that the fittings have fully settled into the magazine. 



With the air turned off, pull the pin forward and verify the pin set enters the magazine 
and the fitting, and drives the fitting forward into the jaws. 



Last Fitting Position Sensor

 – If the lower-most fitting in the magazine is not seated 

correctly, the sensor will pick this up and the unit will not fire.  This prevents the pin 
set from crashing into the last fitting and damaging the pin set or magazine. 



When no fitting is present or the fitting is not properly aligned, only the green ‘power 
on’  LED will be on and amber sensor LED will be off. 

Figure 2.7.1 

If a fitting is properly seated in the magazine, the sensor will detect this and display a                       

Amber LED as well as the single green ‘power on’ LED.  Shown in the figures below is the 
sensor with and without fittings. 

Figure 2.7.2