Terminator Iron Filter Installation & Startup Guide
Page 14
www.cleanwaterstore.com
Rev 042414
Troubleshooting the Fleck 2510 Terminator iron filter
One problem that may occur is if you do not have enough backwash flow rate to properly clean the
Terminator iron filter. You can verify the backwash flow rate by running the drain line into a bucket and
timing it when the Fleck 2510 is in Cycle 1 or backwash.
If you are still getting some iron through the system, you can adjust the filter to backwash every 1 or 2 days
