11
TROUBLESHOOTING GUIDELINES
Loss of Vacuum:
Ensure recovery tank drain valve is closed.
Ensure recovery tank access lids are on properly.
Check recovery tank lid gaskets are in good
condition.
Check stainless steel blower protection filter, clean if
required.
Check vacuum tank lint basket, clean if required.
Check for blockage in cleaning tool or vacuum hose.
Check vacuum hoses for kinks, and good
connections.
Check vacuum hose between blower and recovery
tank.
Check belt tension between blower and pto shaft.
Check belt tension at front of pto shaft.
Loss of Water Pressure
Check fresh water tank for adequate water level, if
connected to direct feed water tap ensure tap is in
the on position.
Inlet water feed line collapsed or clogged.
Inline water filter strainer clogged or damaged.
Air leak on the inlet water line from water source to
high pressure pump.
Check BPR (Balanced Pressure Regulator) for
blockage and proper setting.
Check for lose pump belt.
Check chemical jug, ensure there is enough
chemical.
Water Pulsation
Foreign material in pump valves.
Air leak on the inlet water supply line.
Air leak on chemical metering line.
Inadequate water supply.
Foreign material in BPR (Balanced Pressure
Regulator).
No Hot Water
Check temperature control valve setting, ensure its
turned to hot.
Check engine coolant level, top up if required.
Flush heat exchangers with approved coil cleaner.
Possible air lock in water flow system, make sure
coolant level is at proper level then open pet-cock
valves located on the heat exchangers and bleed air
from heat exchangers, then close pet-cock valves.
If problems persist contact your nearest Cleanco
service center.
No Chemical Feed
Check chemical jug level and top up if necessary.
Check chemical feed hose for leaks or cracks.
Check chemical feed check valve located on the
end of the chemical feed hose in the chemical jug
for blockages.
Check chemical flow-meter for blockages.
Check chemical feed hose from front panel to
chemical injector tee for leaks or cracks.
No Unit Power
Check in-line fuse located at the vehicle battery or
fuse box accessory post.
Check to ensure recovery tank is not full.
Check recovery tank shut-off switch for proper
operation.
Check front pto clutch power and grounding wires.
Check unit power rocker switch for lose wires.
Check Hi-Temp shut-off connections on heat
exchanger and at wiring harness.
Unit Will Not Idle Up
Ensure vehicle is in park.
Ensure Park Brake is engaged.
Check which lights are flashing on E.T.M., all should
be on steady. IF no lights are on check fuse #30 on
GM’s.
If unsuccessful see your local authorized Cleanco
service center.
Unit Shuts Down Unexpectedly
Check recovery tanks level and drain if required.
Check in-line fuse located at the vehicle battery.
Check recovery tank shut-off switch to ensure proper
function.
Check Hi-Temp shut-down on heat exchangers.
Check pto clutch power and grounding wires.
Check Hi-Temp shut off on heat exchangers.
Summary of Contents for Compact 45
