Page 11 of 11
Completing the Installation
1.
Before finalizing installation, make sure the CleanCut Ultra-Low is in proper position and fully
compressed. Press firmly and evenly on the CleanCut Ultra-Low to ensure proper placement.
Thoroughly wipe tub area with isopropyl alcohol where the adhesive will bond and allow enough
time for the isopropyl alcohol to flash off before applying the adhesive.
Do not
apply the isopropyl
alcohol directly on the adhesive as it will prevent the adhesive from drying or curing.
Do not
use to
clean or smooth your final bead.
2.
It is necessary to caulk around the entire perimeter of the CleanCut Ultra-Low using the enclosed
adhesive. Begin by using adhesive along the inside of the CleanCut Ultra-Low, one section at a
time. Begin on the left inside and complete the application process, before moving to the bottom
inside, then the right inside. Complete the same steps on the outside. It is recommended that you
wear gloves during this step to avoid direct exposure to the adhesive.
3.
Run your gloved finger along the beads and wipe the excess on a folded paper towel. Try to
smooth the beads one-time only, as the adhesive becomes tacky to the touch quickly.
4.
Underneath the bottom edges of the CleanCut Ultra-Low are a bit more difficult to see and the
included angled nozzle should be used in completing this step. Use a small mirror to inspect the
bead and to verify that all surfaces have been properly sealed.
5.
It is also recommended to remove the stopper from the tub upon completion of the installation to
prevent from accidentally filling the tub with water and, if desired, replace trip lever with a blank cap.
6.
Spend some time at the end of the job to again clean up the tub and bathroom area. Upon
completion, place a sign on CleanCut Ultra-Low warning not to use the tub for 2 days while the
adhesive cures.
IMPORTANT REMINDER – if completing the install on behalf of another, please leave the
warranty and care & use information with the end-user at the conclusion of the installation.
The CleanCut Ultra-Low installation is now complete.
Safeway Safety Step, LLC (DBA CleanCut)
sincerely thanks you for your interest in the CleanCut Ultra-Low and looks forward to assisting you in any
way possible. Visit our website at www.cleancutbath.com for video installation instructions and answers to
frequently asked questions, or call us toll-free at 877-882-7837 with any questions or concerns.
