background image

I

MPORTANT

S

AFETY

I

NSTRUCTION

1) DO NOT

leave the electric scrubber

when plugged in. Unplug from outlet when
not in use and before servicing.

2) 

Turn 

OFF

all controls before unplug-

ging.

3)

This is 

NOT

a toy. Close attention is

necessary when  used around or near chil-
dren.

4)

Use only as described in this safety

manual. Use only manufacturer's recom-
mended attachments and accessories.

5) DO NOT

use electric scrubber with

damaged cord or plug. If the scrubber is
not working as it should, because it has
been dropped, damaged, left outdoors or
dropped into water, contact an authorized
service center or the factory.

6) DO NOT

pull electric scrubber by the

cord, use cord as a handle, close a door
on cord or pull cord around sharp edges
and corners. 

DO NOT

run scrubber over

cord.  Keep the cord away from heated
surfaces.

7) DO NOT

unplug the scrubber by pulling

on the cord. To unplug, grasp the plug,
not the cord.

8) DO NOT

handle the plug of the electric

scrubber with wet hands.

9)

Store scrubber indoors in a dry area.

DO NOT

expose to freezing temperatures.

10) DO NOT 

use this scrubber for dry

vacuuming. This scrubber is not fitted with
a fine dust filter.

11) DO NOT

use the scrubber to pick up

flammable or combustible liquids such as
gasoline or use in areas where they may
be present.

12) DO NOT

use this scrubber to clean

surfaces that have dust or substances
which are flammable, poisonous, caustic,
or irritants and represents a health hazard.

13) DO NOT

use where anesthetics or

oxygen are used.

14

DO NOT

use an extension cord unless

absolutely necessary. If an extension cord
is used, then wire size must be #14 or
larger and should not exceed 50 feet in
length. The extension cord must be a
three-wire grounded type.

15)

Replace damaged or worn parts

immediately with genuine original equip-
ment parts to maintain safety and to pro-
tect your limited warranty. 

16) DO NOT

run pump dry. When the

solution tank is empty, turn off the pump.

17) NEVER 

drive scrubber over steps.

Electrical equipment must be connected
to a properly grounded outlet only. (

See

grounded instructions) 

P

AGE

2

To Avoid Electric Shock, Do Not Expose To Rain

Store Indoors.

When using this equipment basic precautions should 

always be followed, including the following:

W

ARNING

This scrubber is designed to be safe when
used to per-form cleaning functions as
specified. Should damage occur to electri-
cal parts, the unit should 

NOT

be used

until the damage is repaired by the manu-
facturer or an authorized service center.
This will avoid further damage to the
scrubber or injury to the user.

These instructions are for your protection
and information. 

PLEASE READ CARE-

FULLY!

Failure to follow instructions or

precautions could result in injury or dam-
age to the user and/or the scrubber.

C

ARE

O

F

T

HE

S

CRUBBER

Summary of Contents for MasterCraft RA-300









Reviews: