Copyright ©2006 by Cleanfix Cleaning Systems, Inc., 465 West Main St., Wyckoff, NJ 07481.
All rights reserved. Content is subject to change.
CARE OF SCRUBBER
This scrubber is designed to be safe when used to
perform cleaning functions as specified. Should
damage occur to electrical parts, the unit should
NOT be used until the damage is repaired by the
manufacturer of an authorized service center. This
will avoid further damage to the scrubber or injury
to the user.
These instructions are for your protection and
information.
PLEASE READ CAREFULLY! Failure to follow
instructions or precautions could result in injury or
damage to the user and/or the scrubber.
SAVE THESE INSTRUCTIONS!
PARTS & ACCESSORIES
•
The disk connected to the motor and the
on/off switch on the handle of the plastic
molding are standard
•
Reversible telescope handle, including the
adjustable grip.
•
Battery, NiCd 9,6 V 1900 mAh.
•
Quick battery charger 120 V
•
Nylon brush (several models, different
degrees of coarseness, suitable for several
purposes, available)
•
Nylon pads (different degrees of
coarseness available)
•
Microfiber
pad
•
Solution
dispenser.
BEFORE USING THE SCRUBBER
1. Check that voltage of power source is the
same as battery charger. (120 V)
2. Charging of the battery is only permitted in
dry areas.
3. Put the plug of the charger in the wall
socket and place battery in the charger.
4. Use only battery chargers which are
approved by your dealer.
5. When the green light shows, battery is
charged and is ready for use.
6. Remove battery from charger and insert
into the special opening of the machine
head.
7. Press battery firmly down till bottom. The
catches on the battery take care of bringing
the battery into the right position inside the
machine.
8. Place the brush with nipples up in the holes
of the drive disk on the bottom of the motor.
9. If the nylon brush loses its shape it can be
straightened by immersing the brush in hot
water for 30 seconds. The brush will regain
its original shape.
10. Working with pads, they should be placed
as central as possible on the driving disk
and directly attached to the Velcro.
11. The right working position, depending on
the job, will be obtained by fixing the
telescope handle on the correct length,
using the plastic turn lock.
12. Use the screw buttons, to fix the adjustable
handle in the preferred position.
13.
Check that the machine is in proper
condition.
14. Remove obstacles, such as furniture etc.
from the area to be cleaned. Large pieces
can be removed to opposite end of the
room from where you start cleaning.
15. All covers, hoods and lids must be correctly
attached and closed. Make sure all
switches are in the OFF position.
Reversible telescopic handle
16. Place the telescopic handle in the opening
of the handle at the motor part and press
firmly until the fixing button on the
connector comes up. Tighten the fixing bold
on the iron support slightly.
17. Before removing the handle, first loosen the
fixing bolt on the iron support slightly. Push
the button on the connector of the handle
and pull to remove while holding the button.
