SPRacingF3NEO
http://seriouslypro.com - http://cleanflight.com
Page 10
Additional or replacement cables are available from your retailer.
Do not rely on cable color-coding due to manufacturer variations. Always check before applying power.
Configuration.
Verify NEO operation via the configuration software.
• Disconnect the NEO from your computer.
• Install latest STM32 Virtual COM Port Driver
http://www.st.com/web/en/catalog/tools/PF257938
• Install and launch the Cleanflight Configurator tool
https://chrome.google.com/webstore/detail/cleanflight-configurator/enacoimjcgeinfnnnpajinjgmkahmfgb
• Connect flight controller to computer via USB cable.
• Select the correct COM port if it is not automatically detected.
• Click connect, verify that communication is established.
Disconnect and
upgrade the firmware
using the Cleanflight configurator tool. (See Firmware Upgrade section).
For further software configuration see the Cleanflight manual.
DFU driver installation.
A DFU driver is required to flash the latest firmware.
• Disconnect the NEO from your computer.
• Launch the cleanflight configurator.
• Press and hold the BOOT button.
• Connect the NEO to your computer.
• Release the BOOT button.
• If ‘DFU’ appears in the port selection then a DFU driver is installed, disconnect the NEO and then follow Firm-
ware Upgrade procedure.
• If ‘DFU’ does not appear in the port selection then a DFU driver must be installed now.
• Install Zadig.
http://zadig.akeo.ie/
• Run Zadig, From the menus enable ‘Options / List all devices’.
• Select the ‘STM32 Bootloader’ device in the list.
• Select WinUSB to the right of the green arrow.
• Click ‘Replace driver’ and follow prompts to install the DFU driver.
• Restart this process from the beginning to verify DFU driver installation is correct.
