20
1. Remove the water tank by pulling it upwards out of the device. Open the
water tank cap, fill it with cool and clean tap water or distilled water (to
protect against lime scale build-up) and close it. Put the water tank back
into the device.
Check if the air tube is correctly installed in the tank cap
and if the tank fits correctly on the water filter.
Fill the water tank up to the maximum mark.
2. Put the plug into the mains socket. The device is warmed up after approx. 60 seconds.
3. Now clean the surfaces by gently moving the cleaning foot forwards and backwards, while
pushing the steam trigger to emit steam.
4. When you wish to replace or wash the floor cleaning cloth, first switch off the device and
remove the plug from the mains socket. In order to switch off the steam cleaner, release the
trigger. Never pull on the cable, but always on the plug. Wait for 5 minutes to ensure that
the device is cool. Now you can replace the floor cleaning cloth.
Steam will be produced for a further 30 seconds once the device has been switched
off! Do not turn the steam cleaner upside down when replacing the floor cleaning
cloth.
5.
When the steam cleaner doesn’t produce any more steam during the cleaning process,
release the steam trigger. Remove the plug from the mains socket and refill the water tank as
described.
6. After finishing the cleaning process and leaving the device cool down, empty the water tank.
7. Before using the steam cleaner again please check the water tank for any residual water. If
necessary empty the tank completely.
Care and Maintenance
❐
The plug mustn’t put into the mains socket while cleaning the device.
❐
Never immerse the device in water and don’t rinse it under running water.
❐
Do not use any corrosive or abrasive cleaning agents.
1. Release the steam trigger and remove the plug from the mains socket. Never pull on the
cable, but always on the plug.
2. If necessary wipe with a damp cloth. Only use a mild soap when cleaning.
The safety standards of this device can only be assured if it is checked regularly for damage and
wear. In order to avoid water leaking out of the water tank when connecting the tank and/or the
filter, please carry out the following instructions:
06120_DE-GB-FR-NL_V1.indb 20
23.02.10 09:26
