CleanSpace CS302 User Instructions Download

Page: 5 / 90

Using a full face mask with the rain cover raised can cause the exhalation valve to vibrate, which you may notice as a

buzzing noise. Lower the rain cover for correct operation.

The blower contains a battery, sensitive electronics and a motor. Never immerse it in water or use anything wetter

than a damp cloth to clean it.

You must recalibrate the internal pressure sensor any time that your CleanSpace HALO is exposed to changes in

temperature of more than 20°C. It is best practice to also re-calibrate if the unit has been in storage, particularly if the

storage temperature is not known.

To check that the test port plug is fitted correctly (after using the on-board fit test ports), a negative pressure Seal

Check shall be performed – see page 25.

5. NIOSH – Approval, Cautions and Limitations

NIOSH APPROVAL

CleanSpace HALO is a NIOSH-approved respirator system. Refer to these User Instructions and to the NIOSH
approval label provided with each CleanSpace HALO for a listing of components that can be used to form a NIOSH-
approved respirator.

NIOSH CAUTIONS AND LIMITATIONS

A - Not for use in atmospheres containing less than 19.5 percent oxygen.
B - Not for use in atmospheres immediately dangerous to life or health.
C - Do not exceed maximum use concentrations established by regulatory standards.
F - Do not use powered air-purifying respirators if airflow is less than four cfm (115 lpm) for tight fitting facepieces or

six cfm (170 lpm) for hoods and/or helmets.

I – Contains electrical parts that may cause an ignition in flammable or explosive atmospheres.
J - Failure to properly use and maintain this product could result in injury or death.
L - Follow the manufacturer's User's Instructions for changing cartridges, canister and/or filters.
M - All approved respirators shall be selected, fitted, used, and maintained in accordance with MSHA, OSHA, and

other applicable regulations.

N - Never substitute, modify, add, or omit parts. Use only exact replacement parts in the configuration as specified

by the manufacturer.

O - Refer to User's Instructions, and/or maintenance manuals for information on use and maintenance of these

respirators.

P - NIOSH does not evaluate respirators for use as surgical masks.
S - Special or critical User's Instructions and/or specific use limitations apply. Refer to User's Instructions before

donning.

6. S - Special or Critical User Instructions

This respirator contains a system for synchronizing with your breathing and regulating mask pressure.

This system

requires re-calibration whenever it experiences a change in temperature of more than 36°F (20°C). It is best
practice to also re-calibrate if the unit has been in storage, particularly if the storage temperature is not
known.

For the most accurate battery charge indication, the respirator must be plugged into its charger. To be sure it is fully
charged, plug in the charger and wait for

all 3 LEDs to light solidly without flashing

. If the 3

LED is flashing

rapidly, the battery is 95% charged.

The CS3024 Head Cover shall only be used in combination with a HALO Half Mask configured with the HALO BIO
Exhalation Valve Cover, and with the CS3025 Filter HE – HALO BIO. No other combination of mask and filter is
approved for use with the HALO BIO Head Cover. Note: The HALO BIO is a tight-fitting half mask PAPR. The head
cover does not provide or contribute to the system’s respiratory protection.